Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
This guide shows how to replace the engine oil and filter on the Suzuki Access 125 scooter. First, open the stand and secure the vehicle. Next, open the oil filler cap and unscrew the 14 mm drain bolt from the bottom of the scooter. Position a container for fluid disposal. Perform a cleaning cycle with diesel or a suitable additive to remove old oil. Install the new washer on the drain plug and refit it. Unscrew the three 8 mm bolts securing the filter cover and remove the old cartridge and washer. Install the new components after cleaning the housing and tighten the cover in place. Refill the oil tank and run the engine for a few minutes; then, check and adjust the fluid level.

Updated on 28 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the engine oil in the Suzuki Access 125 scooter?
How to replace the engine oil in the Suzuki Access 125 scooter?
Access 125 Replacing the motor oil in the Suzuki Access 125 scooter, as we can see in this tutorial, is an extremely simple and quick operation. First of all, w…
How to perform an oil change on the Access 125 scooter
Access 125 Today we will explain how to replace the engine oil of the Suzuki Access 125 scooter and the corresponding oil filter. We start the replacement by op…
How to replace the engine oil in the Suzuki Access 125 scooter?
How to replace the engine oil in the Suzuki Access 125 scooter?
Access 125 In this tutorial we can see how to replace the engine oil in the Suzuki Access 125 scooter, a very simple and quick operation. First of all, make sur…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos