Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Below are the instructions for replacing the coolant in the Sym Joymax 125 scooter. First, place the scooter on its stand and begin unscrewing the drain screw located on the water pump casing, allowing the fluid to drain into a container for about ten minutes; then unscrew the radiator filler cap located at the front (removing the plastic cover to access it), as shown in the video. At this point, top up with the new antifreeze until reaching the maximum level.

Posted on 13 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Top Up Coolant on Sym Joymax 250-250i-300
How to Top Up Coolant on Sym Joymax 250-250i-300
Joymax 250 In today's tutorial video, learn how to top up the coolant on a Sym Joymax 250-250i and 300 scooter. First, remove the plastic cover that conceals th…
How to Reset the "Service" Light on a Sym Joymax 250
Joymax 250 Before starting, sit on the rider's seat of your Sym Joymax 250. Begin by turning the key in the ignition switch to power up the instrument panel. Ne…
How to Replace the Radiator Fluid on Sym Joymax 250i
Joymax 250 In this video, see how to replace the radiator fluid on a Sym Joymax 250i - 300i scooter by following these simple steps. First, remove the plastic c…

How to Replace the Spark Plugs on a Honda CBR 1000RR

Today's instructions will show you how to remove and replace the engine spark plugs on a Honda CBR 1000RR motorcycle. First, place your bike on a stand and start unscrewing the fuel tank mounting screws; disconnect the electrical connector and the fuel hose to remove it, as shown in the video. At this point, disconnect the four spark plug connectors using a socket spanner with an extension to remove them; then replace them with new ones of the correct type and thread pitch, screwing them in by hand before tightening gently!

Watch the video!


by ScegliAuto

More videos