Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to reset the Service light of the Sym HD 200 Evo, you need to remove the dipstick for checking the oil level. If the oil level is between the maximum and minimum indicated by the dipstick, it means that you can proceed with the reset of the light. To do this, you will need to insert the ignition key into the ignition switch and turn on the instrument panel; you will need to press the button located at the bottom right of the panel until the kilometers remaining until the oil change appear. By continuing to hold down the same button, the Service light below the speedometer will turn off after a few seconds.

Posted on 7 August 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Oil Check Light on the Sym HD 200?
How to Reset the Oil Check Light on the Sym HD 200?
Hd 200 Evo To reset the Oil Check light on the Sym HD 200, you need to extract the dipstick for checking the oil level. If the level is between the maximum and …
How to Replace the Battery of the Sym HD 200
How to Replace the Battery of the Sym HD 200
Hd 200 Evo This guide shows how to replace the battery of the Sym HD 200 Evo. The scooter's battery is located under the floorboard. Access this component by re…
How to Change the Engine Oil of the Sym HD 200
How to Change the Engine Oil of the Sym HD 200
Hd 200 Evo Today, follow these step-by-step instructions to change the engine oil and oil filter of the Sym HD 200 scooter. First, place the scooter on its cent…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos