Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Tm Racing Smr 125
Part: Engine

In these quick steps, we will see how to disassemble the engine block from the frame of the TM Racing SMR 125 motorcycle. First, we remove the rider's seat and begin to disconnect the suspension and remove the side chains; then we remove the drive chain and disconnect it from the sprocket, as shown in the video. At this point, we disconnect the radiator pipe and drain the oil; disconnect the fuel line from the tank and unscrew the bolts of the engine block attached to the frame, then remove the entire engine block permanently!

Posted on 20 September 2024 by ScegliAuto

Video tutorial

Related tutorials

How to overhaul the engine of the TM Racing SMR 125
How to overhaul the engine of the TM Racing SMR 125
Smr 125 In this short and simple guide, we will see how to carry out a complete revision of the entire engine block of the TM Racing SMR 125 motorcycle. Firs…
How do you remove the engine from the TM Racing SMR 125?
How do you remove the engine from the TM Racing SMR 125?
Smr 125 To remove the engine from the TM Racing SMR 125, you need to loosen the screws that secure it in place. At this point, you can proceed to disconnect …
How to Dismantle the Engine of the TM Racing SMR 125?
How to Dismantle the Engine of the TM Racing SMR 125?
Smr 125 To dismantle the engine of the TM Racing SMR 125, loosen the screws that secure it to its housing at the central lower part of the frame: once the su…

Changing the Oil and Filter on the Kawasaki Versys

Here’s how to change the oil and filter on the Kawasaki Versys. Warm up the engine for a few minutes, place the motorcycle on the centre stand, open the filler cap, and remove the drain plug underneath the engine. Place a catch basin under the oil sump, unscrew the drain plug, and let the oil drain out. Unscrew the oil filter and let all the old oil drain out. Install a new filter and tighten it with the appropriate tool. Pour half a glass of new oil into the filler cap and wait for it to flow out of the drain hole, after which replace the plug. Fill with approximately 1.8 litres of new oil, take it for a short ride to circulate the oil in the engine, stop the engine, and check the level through the designated window. Top up if necessary.

Watch the video!


by ScegliAuto

More videos