Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the license plate holder of the TM Racing 125, you will need to loosen the screws that hold it to its housing: these screws will be located in the lower rear part of the rear fender. Once the screws have been loosened, you can proceed by detaching the component from its housing: you can then place the new one in its seat. In this way, you will need to secure it by inserting the screws that were previously removed and adjusting the tilt of the license plate; finally, you will need to verify that the piece has been securely welded to its seat.

Posted on 29 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the piston of the TM Racing 125?
How do you replace the piston of the TM Racing 125?
Tm Racing 125 In order to replace the piston of the TM Racing 125, you will need to loosen the screws that secure the engine block to its housing, which is located…
How do you replace the exhaust pipe of the TM Racing 125?
How do you replace the exhaust pipe of the TM Racing 125?
Tm Racing 125 To replace the exhaust of the TM Racing 125, you need to loosen the screws that secure the side panel of the rear fender: once this panel is removed,…
How to Replace the Exhaust on TM Racing 125?
How to Replace the Exhaust on TM Racing 125?
Tm Racing 125 The procedure for replacing the exhaust installed on the TM Racing 125 involves loosening the screws that secure the exhaust end can to its housing, …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos