Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Tm Racing En 125
Part: Pump

This guide provides the main instructions on how to remove and replace the water pump on the TM Racing EN 125 enduro bike. First, place the bike on a stand and disconnect the coolant hose, allowing the fluid to drain into a container for about ten minutes; then unscrew the bolts of the water pump cover, remove it, and replace it with a new one, as shown in the video. At this point, install the new water pump, reconnect the hose, and refill with new coolant.

Posted on 4 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you remove the engine of the TM Racing EN 125?
How do you remove the engine of the TM Racing EN 125?
En 125 In order to remove the engine of the TM Racing EN 125, you first need to loosen the screws that secure it to the respective supports on the frame, in…
How do you disassemble the engine of the TM Racing EN 125?
How do you disassemble the engine of the TM Racing EN 125?
En 125 In order to disassemble the engine of the TM Racing EN 125, you must loosen the screws that fix the cylinder to the top of the engine block, so that …
How do you replace the engine oil of the TM Racing EN 125?
How do you replace the engine oil of the TM Racing EN 125?
En 125 In order to replace the engine oil of the TM Racing EN 125, you need to loosen the drain plug, located in the central lower part of the motorcycle: o…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos