Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Tm Racing En 125
Part: Engine

In order to disassemble the engine of the TM Racing EN 125, you must loosen the screws that fix the cylinder to the top of the engine block, so that it can be completely removed from its housing: the piston inside it must be removed from the connecting rod by widening the fixing ring. At this point, it will also be possible to remove the connecting rod from the engine shaft and access further internal components; once the necessary parts have been replaced, it will be possible to close the engine by reinserting all the previously removed parts.

Posted on 6 August 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you remove the engine of the TM Racing EN 125?
How do you remove the engine of the TM Racing EN 125?
En 125 In order to remove the engine of the TM Racing EN 125, you first need to loosen the screws that secure it to the respective supports on the frame, in…
How do you replace the engine oil of the TM Racing EN 125?
How do you replace the engine oil of the TM Racing EN 125?
En 125 In order to replace the engine oil of the TM Racing EN 125, you need to loosen the drain plug, located in the central lower part of the motorcycle: o…
How to Replace the Water Pump on the TM Racing EN 125
How to Replace the Water Pump on the TM Racing EN 125
En 125 This guide provides the main instructions on how to remove and replace the water pump on the TM Racing EN 125 enduro bike. First, place the bike on a…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos