Do it yourself
Frequently asked questions about cars and motorcycles

How to charge the battery of the Toyota Yaris

Model: Toyota Yaris Xp130 - Years: 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019
Part: Battery

See other generations:
Video tutorial

Today we will show you how to connect the booster to a Toyota Yaris Hybrid with a dead battery. Turn on the car's instrument panel and lift the hood release lever.

Lift the cover of the positive pole indicated by the red cover and connect the positive cable of the booster to the battery. Connect the negative cable of the booster to a metal part of the car. Get into the vehicle and check if the battery is actually charging, if not, it will be necessary to proceed with the replacement.

If the battery is charging, we will notice on the instrument panel the percentage that will increase more and more as the minutes and hours pass. To disconnect the cables, we must first disconnect the negative cable and then the positive cable.

Start the car to test the correct functioning of the battery.


Posted on 28 November 2025 by ScegliAuto


Related tutorials

Toyota Yaris (2020-2026 / MK 4) In order to recharge the battery of the Toyota Yaris, you need to open the hood so that you can access the components inside the engine compartment: …
Toyota Yaris (2020-2026 / MK 4) Unlike many Toyota models, the Hybrid Yaris places the battery inside the vehicle. The battery of the Toyota Hybrid Yaris is located within the cabin…
Toyota Yaris (2005-2011 / Xp90) Start by inserting the tip of a flathead screwdriver into the slot on the side of your Toyota Yaris key and lever it open. Then, detach and remove th…

    Frequently Asked Questions

    • Yaris 2011-2019 - How much does it cost to replace the batteries in the Toyota Yaris Hybrid in the UK? Read answer

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos