Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To perform an oil change on the Triumph Speed 400, it is important to make sure that the engine is slightly warm, as the more fluid oil flows better. Place the motorcycle on a stable surface and place a collecting basin underneath the engine. Locate the drain plug located at the bottom of the crankcase and carefully unscrew it, allowing the used oil to completely drain into the basin. After the oil has drained out, securely screw the drain plug back in to prevent future leaks. Now proceed with filling from the top opening: slowly pour in the new oil and check the level using the dipstick or engine indicator, making sure not to exceed the recommended limit. Once the filling is complete, briefly start the engine to allow the oil to circulate, then turn it off and check the level again, adjusting if necessary.

Posted on 28 October 2025 by ScegliAuto

Video tutorial

Related tutorials

How to change the engine oil of a Triumph Speed 400?
How to change the engine oil of a Triumph Speed 400?
Speed 400 To change the engine oil of a Triumph Speed 400, make sure the engine is cold. Lift the motorcycle on a stand to make it stable. Remove the oil cap f…
How to change the gearbox oil of a Triumph Speed 400?
Speed 400 To change the gearbox oil of a Triumph Speed 400, start by positioning the motorcycle on a flat and stable surface, using a center stand or side stan…
How to change the motor oil of a Triumph Speed 400?
How to change the motor oil of a Triumph Speed 400?
Speed 400 To change the motor oil of a Triumph Speed 400, start by warming up the engine for a few minutes to fluidify the oil. Turn off the engine and place t…

How to Replace the Battery in a Yamaha Vino 125 Scooter?

In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos