Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the engine oil in the Triumph Street Triple 765 RS?

Model: Triumph Street Triple 765 Rs
Part: Engine oil

Video tutorial

In this tutorial, we will see how to replace the engine oil in the Triumph Street Triple 765 RS, a very simple and quick operation. First of all, we need to wait for the engine to cool down sufficiently.

Then, we position a container under the bike, locate the drain hole bolt, and unscrew it using a hex key. Next, we let all the oil contained in the system drain out, remove the lower cover, and unscrew the old filter. At this point, all that's left to do is tighten the replacement filter, reassemble everything, and add the necessary amount of oil through the designated upper hole.


Posted on 15 December 2025 by ScegliAuto


Related tutorials

How to replace the engine oil in the Triumph Street Triple 765 RS?
How to replace the engine oil in the Triumph Street Triple 765 RS?
Street Triple 765 Rs .. In this tutorial we can see how to replace the engine oil in the Triumph Street Triple 765 RS, an extremely simple and fast operation... …
How to Reset the Service Light on a Triumph Street Triple 765 RS
How to Reset the Service Light on a Triumph Street Triple 765 RS
Street Triple 765 Rs To clear the Service light on the Triumph Street Triple 765 RS, turn on the ignition and navigate the menu using the controls on the left side of the…
How do you replace the rear brake pads of the Triumph Street Triple 765 RS?
How do you replace the rear brake pads of the Triumph Street Triple 765 RS?
Street Triple 765 Rs To replace the rear brake pads of the Triumph Street Triple 765 RS, first you will need to loosen the screws that secure the brake caliper to the cor…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos