Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Clutch Lever on a Triumph Street Twin?

Model: Triumph Street Twin
Part:

Video tutorial

To replace the clutch lever on a Triumph Street Twin, loosen the nut located at the bottom of the pin that secures the lever to the handlebar. Once this nut is removed, you can extract the pin from its housing and also loosen the cable retaining ring on the lever.

Then, disconnect the cable from the lever and attach the new lever to the same cable, securing it with its ring. Finally, reinsert the lever and secure it with the pin and nut.


Updated on 22 June 2026 by ScegliAuto


Related tutorials

How to Remove the Front Headlight on a Triumph Street Twin
How to Remove the Front Headlight on a Triumph Street Twin
Street Twin Before you start, position your Triumph Street Twin on a paddock stand. Begin by unscrewing and removing the screws that secure the front headlight t…
How to Replace the Spark Plug on a Triumph Street Twin
How to Replace the Spark Plug on a Triumph Street Twin
Street Twin Hello, today's guide aims to replace the spark plug on your Triumph Street Twin. Start by removing the side fairings of the motorcycle. Next, disconn…
Replacing the Battery in the Triumph Street Twin
Replacing the Battery in the Triumph Street Twin
Street Twin Let’s see in this short and simple guide how to replace the battery in the Triumph Street Twin motorcycle, following the instructions below. First, r…

How to Change the Engine Oil on a Honda CRF 250?

To change the engine oil on a Honda CRF 250, start by placing the bike on a stand to ensure it is stable and level. Remove the oil filler cap located on the top of the engine. Position a collection container under the oil drain plug. Unscrew the oil drain plug and allow the used oil to fully drain. Once the oil has drained, remove and inspect the oil filter. Replace it if necessary. Lubricate the seal of the new filter with fresh engine oil and install it. Pour new engine oil through the filler hole using a funnel, following the quantity recommended in the owner's manual. Refit the oil drain plug with the correct torque. Start the engine and let it run for a few minutes to allow the oil to circulate. Turn off the engine and check the oil level. Add oil if necessary. Check for any oil leaks and clean up any spills. Replace the oil filler cap, and you are ready to go!

Watch the video!


by ScegliAuto

More videos