Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

We are closing a hole on the roof of a camper.

Model: (Various brands) Various
Part: Checks and maintenance

Let's see how to proceed to close the hole that used to house a vent on the roof of our Camper. We climb onto the roof and with a marker we trace the perimeter of the surface where we will work, using the panel that will close the vent hole. We outline the traced mark with some masking tape, apply two rounds of white sealing silicone inside the frame, position the closing panel pressing firmly on the surface, apply a bead of silicone on the edge of the panel. We spray a degreaser abundantly on the work done, put on latex gloves and with a finger we trim the edges of the panel removing excess silicone, clean with the degreaser, put a lego board on the panel and weights on top and wait for the silicone drying times.

Posted on 26 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Door Seal of a Camper
How to Remove the Door Seal of a Camper
(Various brands) Various Removing the entrance door seal of a camper is a very simple operation that can be done independently. To remove the seal, first park the camper on l…
How to transport luggage on the roof of your car if you don't have roof racks or rails
How to transport luggage on the roof of your car if you don't have roof racks or rails
(Various brands) Various In this video we can see an indication on how to transport extra luggage on the roof of our car, even if we have not installed not only the crossbars…
Fitting Roof Bars
Fitting Roof Bars
(Various brands) Various If you intend to fit roof bars on your car, the video and description below outline the various steps and necessary information for correct installat…

    Frequently Asked Questions

    • Vari - What does it mean when the message "insp" appears on a car? Read answer
    • Vari - Why doesn't the Becker Map Pilot start? Read answer
    • Vari - What problems does the Kymco Downtown 300i have? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos