Do it yourself
| ||||
|
(Various brands) Various - Video tutorial
Model: (Various brands) Various
The most common thing when a mirror breaks is that the internal support breaks, which is made of an alloy called "zamak" which is almost impossible to weld. Then you have to go to a good electrician who will be able to provide us with perforated pins, which are applied inside the original pin and through which we can pass the mirror cable, and through two bolts we can re-tension the spring that made it work mirror. It is a job that requires a minimum of manual dexterity, because we had to remove the cable from the mirror, disconnect it from the connector of the electric motor, then put it back in place and reconnect it. Not to mention that the internal panel of the car door must also be partially removed, to first disconnect and then reconnect the cables. However, we solved the situation with a few euros, while instead we would have had to replace the entire mirror, with a very substantial expense.
Posted on 15 May 2024 by ScegliAuto
Removing the car exterior rearview mirror
(Various brands) Various Today we will see how to remove the external rearview mirror in a generic car: the procedure can vary from car to car but the main steps remain the s
How to replace the external rearview mirror of the Cadillac Deville.
(Various brands) Various If you need to change the external rearview mirror and you don't know how to do it, then all you have to do is follow the instructions in the followi
How to replace the rearview mirror
(Various brands) Various To get to disassemble and extract the external rearview mirror it will be necessary to perform some preliminary procedures, such as removing the pane Other guides that may interest you
|
Frequently Asked QuestionsFiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.081
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |