|
Do it yourself
| |||
| ||||
Model: Yamaha Xt 660
This guide explains how to bleed and top up the engine coolant for the Yamaha XT 660 and XT 660Z motorcycles. First, remove the plastic cover on the right side of the bike by unscrewing the fixing screws with an Allen key. Next, unscrew the bleed screw located on the water pump casing, allowing the fluid to drain into a container. At this point, unscrew the radiator cap and top up the coolant; fill it to the maximum level, then start the engine to circulate the fluid!
Updated on 13 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Xt 660
This guide shows you how to remove and replace the engine air filter on a Yamaha XT 660 R by following these simple steps. First, remove the rider an…
Xt 660
This guide shows how to remove and replace the air filter of the Yamaha XT 660 Z engine, following the instructions below. First, place your bike on …
Xt 660
In this tutorial, you will see how to change the engine oil in a Yamaha XT 600, a very simple and quick operation. First, ensure that the engine is c…
|
How to Replace the Front Headlight on the BMW F800GS
In this tutorial, you will see how to replace the front headlight on the BMW F800GS, an extremely simple and quick operation. First, ensure the key is not inserted for safety, then locate the power connector at the back of the headlamp and disconnect it by pressing the clip. Next, unscrew the two side bolts using a Torx T40 key, grasp the headlight and pull it away from the support. At this point, you can insert the replacement, tighten the two bolts, and reconnect the power connector. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.007
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
