Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Replacing the headlight bulbs on the Yamaha R6, as shown in this tutorial, is an extremely simple and quick task. First, ensure the key is not inserted. Next, locate the cap at the rear of the headlamp and unscrew it. Then, disconnect the indicated retaining clip, remove the bulb from the housing, and separate it from the power connector. At this point, connect the replacement bulb and follow the reverse procedure, taking care not to touch the glass of the new bulb with bare hands, as any residues can cause overheating.

Updated on 7 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the front headlight bulbs in the Yamaha R6?
How to replace the front headlight bulbs in the Yamaha R6?
Yamaha R 6 As seen in this tutorial, replacing the front headlight bulbs in the Yamaha R6 is an extremely simple and quick operation. First, ensure that the key…
How to Replace the Front Headlamp Bulbs on a Yamaha R6
How to Replace the Front Headlamp Bulbs on a Yamaha R6
Yamaha R 6 This tutorial shows how to replace the front headlamp bulbs on a Yamaha R6, a very simple and quick operation. First, ensure the key is not in the ig…
How to Replace the Exhaust on a Yamaha R6?
How to Replace the Exhaust on a Yamaha R6?
Yamaha R 6 You can replace the exhaust on the Yamaha R6 by unscrewing the screws that secure the exhaust terminal to the corresponding housing on the right side…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos