Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Yamaha Xmax 300
Part: Wheel

This guide will show you how to remove and replace the rear wheel of a Yamaha Xmax 300, following the instructions below. First, place your scooter on the centre stand and begin by removing the exhaust silencer; unscrew the fixing screws as shown in the video. Next, unscrew the screws of the rear brake caliper and remove it from the disc. Loosen the rear fork bolt and unscrew the central nut of the wheel to remove it, replacing the tyre if necessary, and apply the reverse procedure for reassembly!

Updated on 28 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the rear brake disc of the Yamaha Xmax 300
Replacement of the rear brake disc of the Yamaha Xmax 300
Xmax 300 Below we will see the main instructions useful for disassembling and replacing the rear brake disc of the Yamaha Xmax 300 scooter. First of all, we p…
How to Replace the Air Filter of the Yamaha Xmax 300
How to Replace the Air Filter of the Yamaha Xmax 300
Xmax 300 To replace the air filter of the Yamaha Xmax 300, loosen the screws securing the cover near the rear wheel on the left side of the bike. Once these s…
How to Replace the Belt on a Yamaha Xmax 300?
How to Replace the Belt on a Yamaha Xmax 300?
Xmax 300 To replace the belt on the Yamaha Xmax 300, you need to loosen the bolts securing the cover at the rear wheel, on the left side. Once the bolts are u…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos