Do it yourself
Frequently asked questions about cars and motorcycles
To replace the air filter of the Yamaha Xmax 300, loosen the screws securing the cover near the rear wheel on the left side of the bike. Once these screws are loosened, you can detach the cover so that the filter inside can be removed. After the old filter has been taken out of its housing, insert the new replacement part. This should be secured inside its housing, and then cover it all with the corresponding cover.

Updated on 21 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Xmax 300 In this tutorial, you will see how to replace the starter motor on the Yamaha XMAX 300 scooter, a simple operation that requires good manual skills. …
Xmax 300 In this short and simple guide, learn how to carry out the routine maintenance oil change service on your Yamaha Xmax 300 scooter. First, place the s…
Xmax 300 To change the engine oil on the Yamaha Xmax 300, loosen the drain plug located at the bottom left of the bike, next to the stand. Unscrewing the plug…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos