|
Do it yourself
| |||
| ||||
Model: Yamaha Aerox
To replace the grips on the Yamaha Aerox, use a tool to pry off the weights located at the ends of the handlebars. Once both weights are removed, grasp the old grips and pull them outward to remove them from their housing. After these are removed, insert the new replacement grips; these must be secured in place by reinserting the weights. After installation, ensure everything functions correctly.
Updated on 4 September 2026 by ScegliAuto
Video tutorial
Related tutorials
Aerox
Before you can start, head to the front side of your Yamaha Aerox scooter. Begin by unscrewing and removing the screws that secure the front fairing …
Aerox
In order to replace the front brake pads of the Yamaha Aerox, you need to loosen the screws that secure the brake caliper to the corresponding front …
Aerox
In this tutorial, you will see how to reset the service light on the Yamaha Aerox scooter, an extremely simple and quick operation. Before proceeding…
|
How to Service the Piaggio Vespa GTS 300
This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.171
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
