Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial, you will see how to replace the rear light bulbs on a Yamaha NMAX scooter, a very simple and quick operation. First, ensure that the key is not inserted. Then, remove the plastic rivets located on the lower part of the light, open the seat, and unscrew the indicated fixing bolts using an Allen key. Next, grasp the light, pull it outward, and separate it from the support. At this point, simply extract the faulty bulb by turning it counterclockwise, connect the replacement, and follow the reverse procedure.

Updated on 9 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Brake Pads on a Yamaha NMAX Scooter?
How to Replace the Rear Brake Pads on a Yamaha NMAX Scooter?
Nmax In this tutorial, you will see how to replace the rear brake pads on a Yamaha NMAX scooter, a very simple and quick operation. First, position yourse…
How to replace the engine oil in the Yamaha NMAX scooter?
How to replace the engine oil in the Yamaha NMAX scooter?
Nmax In this tutorial we can see how to replace the engine oil in the Yamaha NMAX scooter, an extremely simple and fast operation. First of all, make sure…
How to reset the V-Belt warning light on the Yamaha NMAX scooter?
How to reset the V-Belt warning light on the Yamaha NMAX scooter?
Nmax In the Yamaha NMAX scooter, the V-Belt light indicates the need to perform maintenance on the transmission belt after exceeding the recommended inter…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos