Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. 159
    4. : How to replace the clutch cylinder of the Alfa Romeo 159

Alfa Romeo 159 - Video tutorial

Model: Alfa Romeo 159 MK 1 - Years 2005-2011
Part: Clutch
Operation: How to replace the clutch cylinder of the Alfa Romeo 159

To proceed with the replacement of the clutch cylinder it is necessary to follow the following instructions: open the bonnet, remove the battery terminals and extract it, the fuse box is located immediately next to the battery, proceed to extract that too. Below is the battery support plate that must be disassembled and under it we will find the clutch cylinder. To disassemble the latter, you need pliers to remove the stop of the fitting and unscrew the side tube by hand, at which point it will be possible to remove the cylinder and replace it with a new one. Finally, repeat all the steps in reverse to reassemble all the components.


Posted on 1 May 2024 by ScegliAuto

    Frequently Asked Questions

    • 159 2005-2011 - How much does it cost to replace the clutch in the Alfa Romeo 159? Read Answer
    • 159 2005-2011 - After how many km should the clutch of the Alfa Romeo 159 be replaced? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos