Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Adjust the Headlights on the Aprilia Tuareg 660?

Model: Aprilia Tuareg 660
Part: Headlight

Video tutorial

In this tutorial, you will see how to adjust the headlights on the Aprilia Tuareg 660, a very simple and quick operation. First, position the motorcycle in front of a light-coloured wall, about two metres away, then turn on the instrument panel and activate the dipped beam.

Next, locate the screw at the back of both headlamps, and use a cross-head screwdriver to tighten or loosen it, positioning the beam slightly lower than the height of the bulb. The adjustment bolt for the main beam, which is 10mm, is accessible from the lower area of the front fairing.


Posted on 27 July 2026 by ScegliAuto


Related tutorials

How do you replace the air filter of the Aprilia Tuareg 660?
How do you replace the air filter of the Aprilia Tuareg 660?
Tuareg 660 The replacement of the air filter on the Aprilia Tuareg 660 requires loosening the screws that hold the panel in the front of the vehicle, immediatel…
How to Set the Time on the Aprilia Tuareg 660
How to Set the Time on the Aprilia Tuareg 660
Tuareg 660 Below are the instructions to set the time on the Aprilia Tuareg 660 in simple and quick steps. First, place the bike on its stand and turn on the in…
How to replace the air filter on the Aprilia Tuareg 660?
How to replace the air filter on the Aprilia Tuareg 660?
Tuareg 660 To replace the air filter on the Aprilia Tuareg 660, loosen the screws securing the panel located at the front of the vehicle, just behind the handle…

How to Dismantle the Centre Fairing of the Piaggio MP3

Below are the instructions to dismantle and replace the centre fairing of the Piaggio MP3 500 and 250 scooter. First, place the scooter on its stand and start by removing the small side plastic cover, unscrewing the fixing screws located underneath. Then, remove the fuel cap and disconnect the centre fairing by unplugging the electrical connector found underneath, as shown in the video. At this point, replace and install the new fairing, applying the reverse procedure for reassembly!

Watch the video!


by ScegliAuto

More videos