|
Do it yourself
| |||
| ||||
Model: Aprilia Sr 50
Follow these instructions to remove and replace the rear brake pads on the Aprilia SR 50 scooter. First, place the scooter on its centre stand and begin unscrewing the bolts securing the rear brake caliper, removing it from the disc. Next, remove the central locking pin for the pads, then refit the new brake pads as shown in the video. At this point, clean the caliper of any residual dirt before installing the new pads; reattach the brake pads to the caliper and finally, refit the caliper onto the disc!
Updated on 28 July 2026 by ScegliAuto
Video tutorial
Related tutorials
Sr 50
This guide will show you how to remove and replace the front brake pads on an Aprilia SR 50 scooter, following the instructions below. First, place y…
Sr 50
To replace the front brake pads of the Aprilia SR 50, loosen the screws that secure the caliper to the disc, allowing it to be removed and the old pa…
Sr 50
Before you begin, sit on the seat of your Aprilia SR 50. Start by turning the key in the ignition switch to activate the instrument panel. Next, pres…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.005
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
