Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Aprilia Rx 125
Part: Engine oil

Following these brief instructions, you will see how to perform the routine maintenance service by replacing the engine oil and oil filter on the Aprilia RX 125 motorcycle. First, place the bike on the stand and begin to unscrew the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then unscrew the screws of the oil filter cover to remove and replace the cartridge with a new one, as shown in the video. At this point, unscrew the filler cap and pour in the new engine oil, ensuring you use the correct amount.

Updated on 16 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil and Oil Filter on an Aprilia RX 125
Rx 125 Here are the main instructions for performing routine maintenance by changing the engine oil and oil filter on the Aprilia RX 125 enduro bike. First,…
How to replace the engine oil and oil filter of the Aprilia RX 125.
How to replace the engine oil and oil filter of the Aprilia RX 125.
Rx 125 Today's instructions will allow us to perform the routine maintenance service by replacing the engine oil and oil filter of the Aprilia RX 125 motorc…
How to Replace the Engine Oil and Oil Filter on an Aprilia RX 125
How to Replace the Engine Oil and Oil Filter on an Aprilia RX 125
Rx 125 Replacing the engine oil and oil filter means performing the routine maintenance service on your engine; in this case, we will see how to do it on th…

How to Replace the Air Filter on a Harley Davidson Dyna?

To replace the air filter on a Harley Davidson Dyna, loosen the screws securing the cover located on the right side of the bike, just below the fuel tank. Once the cover is removed, you will locate the filter underneath: it must be removed from its housing by unscrewing the fastening screws and sliding it out from its compartment. After the old filter has been removed, position the new replacement part, securing it in place with the screws and covering everything with the cover.

Watch the video!


by ScegliAuto

More videos