Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to mount the towbar on Audi A4

Model: Audi A4 B7 - Years 2004-2008
Part: Checks and maintenance

Let's see how to mount the metal towbar on an Audi A4. After removing the rear bumper from the car: place the black metal bar in the slots on the car frame, then insert the (metal) bars of the bumper into the sheet. We screw the locking pins into the threads of the frame with a socket wrench (we tighten the pins well). We pass the wiring of the power supply inside the new assembled frame (we use plastic clamps). We mount the rear bumper and all related parts. We carefully check the exact assembly of the previously assembled pieces.

Posted on 21 September 2019 by ScegliAuto

Video tutorial

Related tutorials

How to install rear wiper motor on Audi A4 B7
How to install rear wiper motor on Audi A4 B7
Audi A4 (2004-2008 / B7) In today's video we will see how to install the rear wiper motor on an Audi A4 B7. First of all, let's place the new wiper motor on the boot lid, whe…
How to set the clock on the Audi A4
How to set the clock on the Audi A4
Audi A4 (1994-2000 / B5) The instructions in this guide will show us how to change the time on the Audi A4, in simple and quick steps. First, we get into the car and start th…
How do you replace the door lock of the Audi A4?
How do you replace the door lock of the Audi A4?
Audi A4 (2007-2016 / B8) In order to replace the door lock of the Audi A4, you need to pry with an object so that the trims on the top and middle part of the door panel can b…

    Frequently Asked Questions

    • A4 2007-2016 - Where is the Audi A4 fuel pump relay located? Read answer

How to Replace the Thermostat on a Fiat Punto 2 Series 8v

When replacing the thermostat, it is advisable to drain the coolant system completely. The thermostat is located just above the gearbox, directly under the ignition coils. To facilitate the replacement, disconnect the intake duct hose and remove the coil pack. At this point, disconnect the connector from the thermostat and proceed to remove the corresponding fixing pins to replace it with the new one, ensuring to use a new gasket.

Watch the video!


by ScegliAuto

More videos