Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removal and Replacement of the Rear Seat

Model: Audi A4 B6 - Years 2000-2004
Part: Seat

First, locate the clips underneath the seat on both sides. Press the clips with your finger and lift the seat. Once the seat is raised, disconnect the electrical power cables for the seat heater. To do this, press the clip on the connector and pull it out. At this point, you can remove the seat from its position and replace it with a new one. To install the new or old seat, simply follow the same steps in reverse order. The vehicle on which this maintenance operation was performed is an Audi A4.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to remove the rear seat of the Audi A4
How to remove the rear seat of the Audi A4
Audi A4 (2007-2016 / B8) The removal of the rear seat or rear bench of an Audi A4 vehicle follows a very simple procedure, which can be carried out independently thanks to ou…
Replacement of the rear windshield wiper motor of the Audi A4
Replacement of the rear windshield wiper motor of the Audi A4
Audi A4 (2004-2008 / B7) In this short guide, we will see the instructions that will allow us to disassemble and replace the rear windshield wiper motor of the Audi A4. First…
How to Replace the Rear Door Lock on an Audi A4
How to Replace the Rear Door Lock on an Audi A4
Audi A4 (2004-2008 / B7) First, disconnect the negative cable from the battery. Now, open the door in question and lift the chrome strip at the top. Then, remove all the scre…

How to Disassemble and Remove the Rear Camera of a Mercedes CLA

In this video, see how to disassemble and remove the camera (where the license plate light is located) from the rear hatch of a Mercedes CLA. First, open the rear hatch of the car, then remove the rear license plate. Use a screwdriver to remove the screws on the plastic trim of the hatch. Disconnect the plastic trim of the license plate light from the hatch, and use a screwdriver to remove the retaining clips (located between the hatch metal and the plastic trim). Finally, remove the rear camera located in the hatch (disconnect the power connector of the camera) of the car. For reassembly, proceed in reverse order.

Watch the video!


by ScegliAuto

More videos