Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Cabin Air Filter

Model: Audi A6 C4, MK 1 - Years 1994-1997
Part: Cabin air filter

Replacing the cabin air filter is a straightforward procedure that you can do yourself without needing help from a trusted mechanic. The following guide shows you how to do it. The first step is to remove the dashboard trim. Be careful, as in addition to the screws to remove, the trim is also secured by clips along its entire length and at the sides. Once you locate the filter, pull it towards you in the same direction it is installed. The rest will be easy. After positioning the new air filter, you can perform the installation procedure in the reverse order of disassembly.

Updated on 21 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Cabin Air Filter Replacement
Cabin Air Filter Replacement
Audi A6 (1997-2004 / MK 2, C5) The cabin air filter is located just below the windshield on the passenger side. To access it, open the hood, remove the seal along the rear edge, an…
Cabin Air Filter Replacement
Cabin Air Filter Replacement
Audi A6 (1994-1997 / C4, MK 1) The cabin air filter is located in the engine compartment, on the passenger side, just below the windshield. To replace it, open the hood, remove the…
How to Change the Air Filter on Audi A6
How to Change the Air Filter on Audi A6
Audi A6 (2004-2012 / MK 3, C6) Need to replace the engine air filter? Here’s how to proceed with the replacement. Open the car door, pull up the engine hood release lever located a…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos