Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To change the motor oil of a Benelli TRK 502, start by making sure you have the correct oil and a container to collect the used oil. Park the motorcycle on a flat and stable surface, ideally using a center stand or a stand. Start the engine for a few minutes to warm up the oil and then turn it off. Place the container under the oil drain plug, located under the engine, and unscrew the plug with a suitable wrench. Let the oil drain completely, clean the drain plug, and if necessary, replace the gasket. Reinsert and tighten the drain plug. Remove the oil filler cap and, using a funnel, slowly pour the new oil into the engine, following the quantity indicated in the manual. Screw the filler cap back on and start the engine for a few minutes to check for leaks. Check the oil level again and dispose of the used oil in accordance with local regulations, taking it to a recycling center or an authorized workshop. By following these steps, you will ensure proper maintenance of the engine of your Benelli TRK 502.

Posted on 23 June 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil on a Benelli TRK 502
How to Change the Engine Oil on a Benelli TRK 502
Trk 502 Start by positioning your Benelli TRK 502 upright using a motorcycle stand. Next, run the engine for a few minutes, then place a container under the …
How to Perform Maintenance (Oil Change) on the Benelli TRK 502
How to Perform Maintenance (Oil Change) on the Benelli TRK 502
Trk 502 Today, in this video tutorial, you will learn how to carry out routine maintenance by replacing the engine oil and oil filter of the Benelli TRK 502 …
How to Reset the Engine Light on a Benelli TRK 502
How to Reset the Engine Light on a Benelli TRK 502
Trk 502 Before you can begin, sit on the seat of your Benelli TRK 502. Start by setting the engine start switch to the active position. Then, fully rotate an…

How to Replace the Front Bulb on the Honda SH 125

This tutorial explains the steps to replace the front headlamp bulb on the Honda SH 125. This is a very simple procedure. First, remove the front shield of the scooter to access the bulb replacement. To perform this first step, unscrew the lower screw and the two upper screws that secure the cover. At this point, the bulb will be clearly visible. Simply unscrew the bulb and insert a new one. It is recommended to carry out this procedure after ensuring that the bulb to be removed has cooled down.

Watch the video!


by ScegliAuto

More videos