Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil on a Benelli TRK 502

Model: Benelli Trk 502
Part: Engine oil

Video tutorial

Start by positioning your Benelli TRK 502 upright using a motorcycle stand. Next, run the engine for a few minutes, then place a container under the oil sump.

After that, unscrew and remove the lower oil drain bolt to let the engine oil drain out. Once all the engine oil has drained, re-screw the drain bolt. Now, unscrew and remove the upper filler cap, add new engine oil, and finally, re-screw the filler cap. When you complete this step, the oil change will be finished.


Updated on 16 April 2026 by ScegliAuto


Related tutorials

Engine Oil Change on a Benelli TRK 502
Engine Oil Change on a Benelli TRK 502
Trk 502 Today, follow these instructions to change the engine oil on a Benelli TRK 502. First, remove the old oil: unscrew the oil drain plug located on the …
How to Replace the Engine Oil and Oil Filter on the Benelli Trk 502
How to Replace the Engine Oil and Oil Filter on the Benelli Trk 502
Trk 502 Today, learn how to replace the engine oil and oil filter on the Benelli Trk 502 motorcycle as part of routine maintenance. First, place the motorcyc…
How to Reset the Engine Light on a Benelli TRK 502
How to Reset the Engine Light on a Benelli TRK 502
Trk 502 Before you can begin, sit on the seat of your Benelli TRK 502. Start by setting the engine start switch to the active position. Then, fully rotate an…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos