Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Benelli
    3. :
  3. Trk 502
    4. : How to replace the rear brake pads of Benelli TRK 502?

Model: Benelli Trk 502
Part: Brake pads
How to replace the rear brake pads of Benelli TRK 502?

In order to replace the rear brake pads of the Benelli TRK 502 it is necessary to loosen the bolts that fix the caliper, so that it can be detached from the relative disc of the rear wheel. Once the caliper has been removed, it will be possible to go and extract the old pads from the inside of the caliper so that the new spare parts can be inserted. Once the new pads have been inserted inside the caliper, it will be necessary to position the latter on its disc, fixing it with the bolts that were previously removed.


Posted on 18 May 2024 by ScegliAuto



Benelli TRK 502 rear brake pads replacement
Trk 502 Today we will see how to remove and replace the rear brake pads on a Benelli TRK 502 motorcycle, following these steps. First we go to unscrew the fi
How to replace the rear brake pads of the Benelli TRK 502.
Trk 502 Today we are going to see the necessary instructions that will allow us to disassemble and replace the rear brake pads of the Benelli TRK 502 motorcy
How do you change the brake pads of the Benelli TRK 502?
Trk 502 In order to replace the brake pads of the Benelli TRK 502 you must first disassemble the speed sensor by removing the bolt and disconnecting the corr

How to change the Harley Davidson Street Glide engine oil and relative filter

The guide shows you how to change the Harley Davidson Street Glide engine oil. The first thing to do is to make the motorcycle safe and unscrew the oil tank cap. At this point, from the bottom of the bike, unscrew the drain plug of the oil pan with a 15mm wrench; allow the oil to flow into a suitable container for disposal. From the left side of the bike, start unscrewing the oil filter and place a plastic bag to collect the oil that comes out. Remove the old filter and clean the housing. Lubricate the gasket on the new filter and install a new O-ring on the drain plug and fit the elements in place. Top up the oil to the correct amount and run the engine. Check the oil level again.

Watch the video!


by ScegliAuto

More videos