Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Adjusting the Carburetion on Beta RR 50

Model: Beta Rr 50
Part: Carburetor

This video is currently unavailable

If your Beta is experiencing strange flat spots, especially uphill, it may be time to adjust the carburetion. To do this, remove the air filter manifold (for better visibility) and loosen the carburettor clips.

Check the spark plug and clean it. Now, note how many turns the carburettor screw has. Remove the slide spring, the slide itself, and the needle. Try adjusting the needle clip based on how rich the spark plug was. If the carburetion seemed too rich, move the needle clip down (if it was on the second clip, move it to the first).

This is the first method: reassemble everything and test the bike. If this is not sufficient, adjust the carburetion by simply working on the carburettor screw, which regulates the fuel flow.


Updated on 29 March 2026 by ScegliAuto


Related tutorials

How to Adjust the Speedometer Clock on a Beta RR 50?
How to Adjust the Speedometer Clock on a Beta RR 50?
Rr 50 To adjust the clock on the Beta RR 50, press both buttons located on either side of the display simultaneously until a menu appears. Use the same but…
How to Remove the Rear Wheel of a Beta RR50
How to Remove the Rear Wheel of a Beta RR50
Rr 50 Before you start, head to the rear wheel and lift the bike slightly. Begin by loosening the fastening nut that adjusts the distance of the rear wheel…
How do you disassemble the engine of the Beta RR 50?
How do you disassemble the engine of the Beta RR 50?
Rr 50 To disassemble the engine of the Beta RR 50, you need to loosen the fixing screws of the supports that hold the engine in its housing in the center o…

How to Change the Engine Oil in the Triumph Tiger 1200 Rally Explorer

In this tutorial, you will see how to change the engine oil in the Triumph Tiger 1200 Rally Explorer, a very simple and quick operation. First, ensure that the engine is cool enough, then remove the lower protective cover, locate the drain hole bolt, and unscrew it using a 7mm hex key. Allow all the oil in the system to drain, unscrew the old filter, and tighten both the replacement and the bolt. At this point, simply pour the necessary amount of oil through the designated upper hole.

Watch the video!


by ScegliAuto

More videos