Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Beta 300 Rr
Part: Engine oil

Before performing the oil change, always warm up the engine for a few minutes to make the circulating oil warmer and less viscous, aiding its subsequent drainage. Remove the lower engine guard by unscrewing its fixing screws. To further assist the oil drainage, first unscrew the upper cap of the engine compartment and then unscrew the bolt that seals the drain hole, allowing air circulation and preventing a vacuum. Collect the used oil in a container and refill with the same quantity. For this motorcycle model, it is recommended to use 10W-40 or 10W-50 oil.

Updated on 8 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the thermostat of the Beta 300 RR?
How do you replace the thermostat of the Beta 300 RR?
300 Rr The thermostat installed on the Beta 300 RR can be found in the area between the engine cylinder and the radiator: in order to extract the thermostat…
How to Dismantle the Engine of the Beta 300 RR?
How to Dismantle the Engine of the Beta 300 RR?
300 Rr To dismantle the engine of the Beta 300 RR, loosen the bolts securing the engine block in its housing. Once the engine is free, extract it from its l…
How to remove the engine from the Beta 300 RR?
How to remove the engine from the Beta 300 RR?
300 Rr The procedure for removing the engine from the Beta 300 RR involves loosening the bolts that secure the engine block within its housing. Once the eng…

How to Replace the Air Filter on a Honda XL1000 Varadero?

In this tutorial, you will see how to replace the air filter on a Honda XL1000 Varadero, a very simple operation. First, remove the seat, then unscrew the two rear mounting bolts of the tank, the two front ones, and the remaining ones located on the sides. Once done, close the two fuel taps, disconnect the rubber hose, and lift the tank. At this point, you will have access to the filter box, which can be opened by removing the 8 screws around the perimeter. Once the filter is replaced, reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos