Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Beta Alp
Part: Engine oil

This guide explains how to perform the routine maintenance service by changing the engine oil and oil filter on the Beta Alp 200 enduro bike. First, place the bike on its stand and remove the panel located under the engine by unscrewing its screws. Next, unscrew the oil drain bolt found under the engine, allowing the oil to drain into a container for about ten minutes. At this point, unscrew the screws of the oil filter cover and replace the cartridge with a new one; finally, top up by pouring in the appropriate oil!

Updated on 11 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Adjust the Valves on the Beta Alp?
How to Adjust the Valves on the Beta Alp?
Alp You can adjust the valves on the Beta Alp by loosening the screws that secure the specific cover, which is located on the left side of the bike and o…
How do you replace the exhaust of the Beta Alp?
How do you replace the exhaust of the Beta Alp?
Alp To ensure that the muffler of the Beta Alp is replaced, you will need to loosen the screws that fix the exhaust terminal to its housing: these screws…
How do you install the skid plate of the Beta Alp?
How do you install the skid plate of the Beta Alp?
Alp In order to install the engine guard plate of the Beta Alp, you need to position this component in the central lower part of the motorcycle, correspo…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos