Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Bmw R1250 Gs
Part: Engine oil

To replace the motor oil of your BMW GS R1250GS, start by making sure the engine is at room temperature. Then, place the motorcycle on a flat and stable surface. Remove the oil cap on the right side of the engine and place a container under the oil drain plug. Remove the drain plug and let the old oil drain completely. Check and replace any damaged gaskets. Tighten the drain plug securely. Fill the engine with the recommended motor oil up to the correct level. Close the oil cap and start the engine to allow the oil to distribute. Turn off the engine and check the oil level using the dipstick.

Posted on 3 November 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Key Battery on the BMW R1250GS
How to Replace the Key Battery on the BMW R1250GS
R1250 Gs In this new mini guide dedicated to your BMW R1250 GS, you will learn how to correctly replace the battery inside the key. This is a relatively simpl…
How to change the motor oil of a BMW R1250 GS?
How to change the motor oil of a BMW R1250 GS?
R1250 Gs To change the engine oil of a BMW R1250 GS, start by placing the motorcycle on a flat surface. Then, lift the motorcycle on the center stand. Remove …
How to Replace Engine Oil on a BMW R1250 GS
How to Replace Engine Oil on a BMW R1250 GS
R1250 Gs In this tutorial, see how to replace the engine oil on a BMW R1250 GS, a very simple and quick operation. First, ensure the engine is cool enough, th…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos