Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To reset the Service light on the BMW K1600, connect a diagnostic tool to the vehicle's OBD port. This port is located under the seat of the motorcycle, so you will need to completely remove the seat to connect the scanner. The port is at the back of the housing: after connecting the tool, select the motorcycle model and the corresponding version. Follow all the instructions to completely reset the light, then disconnect the scanner and turn off the instrument cluster.

Updated on 30 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the maintenance interval (service) of the BMW K1600
How to reset the maintenance interval (service) of the BMW K1600
K1600 In this guide, we will see step by step instructions on how to reset the maintenance interval (service) of the BMW K1600 motorcycle. First, we put th…
How do you replace the exhaust on the BMW K1600?
How do you replace the exhaust on the BMW K1600?
K1600 It will be possible to replace the exhaust of the BMW K1600 by loosening the screws that secure the component to its housing near the rear wheel, on …
How to Replace the Windscreen on a BMW K1600?
How to Replace the Windscreen on a BMW K1600?
K1600 To replace the windscreen on a BMW K1600, you need to loosen the screws that secure it to its housing: there are six screws located at the lower side…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos