Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Spark Plugs on the BMW R1200 GS

Model: Bmw R1200gs
Part: Spark plugs

Video tutorial

Briefly follow the instructions on how to remove and replace the engine spark plugs on the BMW R1200 GS motorcycle. First, place your motorcycle on the centre stand and start by disconnecting the spark plug connectors located on the cylinder head; then use a socket spanner with an extension to unscrew and remove the spark plugs, as shown in the video.

At this point, install the new spark plugs of the correct type and with the same thread size, hand-tightening them before possibly using a torque wrench, following the video tutorial to the end!


Updated on 2 August 2026 by ScegliAuto


Related tutorials

How to Replace the Spark Plugs on a BMW R1200 GS
How to Replace the Spark Plugs on a BMW R1200 GS
R1200gs This guide briefly explains how to remove and replace the engine spark plugs on a BMW R1200 GS, following the instructions below. First, place your b…
How to Replace the Spark Plugs in a BMW R1200 GS
How to Replace the Spark Plugs in a BMW R1200 GS
R1200gs In this tutorial, you will learn how to remove and replace the spark plugs in the engine of a BMW R1200 GS by following these simple steps. First, pl…
How to Reset the "Service" Light on a BMW R1200 GS
How to Reset the "Service" Light on a BMW R1200 GS
R1200gs Before you begin, position your BMW R1200 GS on its side stand. Start by connecting the OBD reader to the bike's port. Next, open the "MOTO SCAN" app…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos