Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Spark Plugs in a BMW R1200 GS

Model: Bmw R1200gs
Part: Spark plugs

Video tutorial

In this tutorial, you will learn how to remove and replace the spark plugs in the engine of a BMW R1200 GS by following these simple steps. First, place your bike on the centre stand and start by removing the frame protection bar, unscrewing the screws found at the anchorage.

Next, remove the spark plug cap to disconnect the connector. At this point, use a socket wrench to unscrew and remove the spark plug, replacing it with a new one (ensuring it has the correct heat rating); now, hand-tighten it before securing it with the wrench!


Updated on 13 June 2026 by ScegliAuto


Related tutorials

Replacing the Spark Plugs on the BMW R1200 GS
Replacing the Spark Plugs on the BMW R1200 GS
R1200gs Briefly follow the instructions on how to remove and replace the engine spark plugs on the BMW R1200 GS motorcycle. First, place your motorcycle on t…
How to Replace the Spark Plugs on a BMW R1200 GS
How to Replace the Spark Plugs on a BMW R1200 GS
R1200gs This guide briefly explains how to remove and replace the engine spark plugs on a BMW R1200 GS, following the instructions below. First, place your b…
How to Replace the Air Filter in the BMW R1200 GS
How to Replace the Air Filter in the BMW R1200 GS
R1200gs In today's video, you will perform a very simple maintenance task on the BMW R1200 GS. Specifically, you will replace the air filter in the BMW R1200…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos