Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Brake Pads on a BMW 1200GS

Model: Bmw Gs1250
Part: Brake pads

Video tutorial

In this video, learn how to replace the rear brake pads on a BMW GS1200: Start by removing the rear mudguard, and you will need to take off the two upper screws. You will need to disassemble the pads from the caliper, and the caliper is attached to the transmission with two screws, which, once removed, allow the caliper to be taken off easily.

To free the pads, you will need to slide out the locking pin, removing the two clips. Once the pads are removed, push the two pistons back and clean the caliper.

You can find replacement parts on all major e-commerce platforms, but we prefer not to specify as models vary greatly depending on the year of manufacture. Typically, the price is around £30. Be careful as the rear pads have a specific orientation for installation.

Insert the pin and clips, close and secure it to the transmission. Refit the mudguard, and the job is complete.


Updated on 9 September 2026 by ScegliAuto


Related tutorials

Replacing the Air Filter on a BMW Gs
Replacing the Air Filter on a BMW Gs
Gs1250 Let’s see how to replace the air filter that supplies the engine of the BMW Gs 1250. Place the bike on the centre stand, remove the two parts of the …
Replacing the Key Battery for the BMW GS 1250
Gs1250 To replace the remote key battery, follow this procedure: open the key and use a finger to pry between the two plastic shells that make up the key. R…
Engine Oil and Oil Filter Replacement BMW GS1250
Engine Oil and Oil Filter Replacement BMW GS1250
Gs1250 Descriptive guide for replacing the engine oil and oil filter on a BMW GS1250. Obtain 4 litres of BMW Advantic SAE 5W40 oil and HIFLO HF160 oil filte…

How to Replace the Handlebars on the Ducati Scrambler

This guide provides instructions on how to remove and replace the handlebars on the Ducati Scrambler motorcycle, following the steps outlined below. First, place the bike on its centre stand and begin removing the grips by unscrewing the screws and taking off the bar ends; then unscrew the handlebar mounting screws to remove the handlebars, as shown in the video. At this point, correctly install the new handlebars to ensure they are centred; then reassemble and secure the grips and side bar ends, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos