Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Left Handgrip Buttons on the BMW R 1200 GS?

Model: Bmw R1200 GS
Part: Push button

Video tutorial

To replace the buttons located at the base of the left handgrip on the BMW R1200 GS, use a tool to pry them away from their housing: you will be able to completely remove them by loosening the screws. At this point, disconnect the connectors attached to the button panel, so that you can connect them to the new replacement part: this can now be installed in its housing, properly fitting it and securing it with the screws, also checking that everything functions correctly.


Updated on 30 September 2026 by ScegliAuto


Related tutorials

How do you replace the exhaust pipe of the BMW R 1200 GS?
How do you replace the exhaust pipe of the BMW R 1200 GS?
R1200 GS To replace the exhaust of the BMW R 1200 GS, you need to loosen the screws that hold it to its housing: this will be located next to the rear wheel o…
How do you replace the front brake pads of the BMW R 1200 GS?
How do you replace the front brake pads of the BMW R 1200 GS?
R1200 GS It will be possible to replace the front brake pads of the BMW R1200 GS by loosening the screws that secure the caliper to its disc: then you will ne…
How to set the time on the BMW R 1200 GS
How to set the time on the BMW R 1200 GS
R1200 GS Let's discover in this guide the steps that will allow us to adjust the time on the display of the instrument panel of the BMW R1200 GS. First of all…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos