Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the Splash Shield Panel

Model: BMW Serie 5 E39 - Years 1995-2003
Part: Body

In this short video, the panel located near the splash shield on the left side of the vehicle, a BMW 5 Series, is replaced. After opening the door, locate the panel. It is attached to the body with three white clips (two on the sides and one in the center). To remove the panel, simply insert your fingers of both hands into the gap near the clips and pull the panel upward. It will detach. To reposition it (or to replace it), just place it back as before and apply some pressure until the clips snap back into place.

Updated on 10 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Oil Leak Repair and Oil Filter Housing Gasket Replacement
Oil Leak Repair and Oil Filter Housing Gasket Replacement
BMW Serie 5 (2003-2010 / E61, E60) Open the hood and locate the oil filter position. Remove the cooling cover (simply clipped) located directly in front of the filter. Lift the front o…
How to Remove Fuel Injectors in 5 Minutes
How to Remove Fuel Injectors in 5 Minutes
BMW Serie 5 (1995-2003 / E39) First, remove the small metal plate that secures the injector clip. Be careful of any diesel fuel that may splash out (while working, always wipe up …
Replacing the Driveshaft Support on BMW 5 Series
Replacing the Driveshaft Support on BMW 5 Series
BMW Serie 5 (2003-2010 / E61, E60) If you don't have a lift, raise the car with a jack and place it on jack stands, but know that a lift is necessary for this job. Once the vehicle is …

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos