Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Steering Rack Tie Rod End Replacement

Model: BMW X3 MK 1, E83 - Years 2003-2010
Part: Control arm

To replace the tie rod end of the steering rack, lift the vehicle on a hydraulic lift and remove the front wheel; then start by loosening the lock nut on the tie rod, just behind the tie rod end; proceed to remove the nut securing the tie rod end to the hub support and use a fork-type puller to extract it from its seat; unscrew the tie rod end from the tie rod, counting the number of turns; screw the new tie rod end onto the tie rod the same number of turns, secure it to the hub support, and tighten the lock nut; in any case, it is recommended to check the alignment on a bench.

Updated on 17 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the engine oil and oil filter of the BMW X3
Replacement of the engine oil and oil filter of the BMW X3
BMW X3 (2017-2024 / MK 3, G01) The following information will allow us to perform the routine maintenance of replacing the engine oil and oil filter of the BMW X3. First, we lift t…
Replacing Car Suspensions
Replacing Car Suspensions
BMW X3 (2003-2010 / MK 1, E83) The following guide shows how to replace your car's suspensions yourself, with minimal knowledge and attention. Suspensions help absorb the stresses …
Replacing the Cabin Air Filter
Replacing the Cabin Air Filter
BMW X3 (2003-2010 / MK 1, E83) The cabin air filter is located in the engine compartment, just below the windshield, in a central position: unscrew the three screws securing the fi…

Other guides you may be interested in

How to Remove the Rear Bumper of an Opel Corsa

How to remove the rear bumper of an Opel Corsa? Follow these steps carefully. This operation is not too complex if done in order. First, use a screwdriver or battery-powered drill to unscrew the securing screws located near the rear lights, then remove them from the body along with their connectors. Unscrew the screws located at the top of the bumper, then unscrew the screws on the sides of the wheel arch liners and at the bottom of the bumper. Once the bumper is free from any screws or pins, grasp it with your hands and pull it away from the body (disconnect any power cables if necessary).

Watch the video!


by ScegliAuto

More videos