Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Oil Leak Repair and Oil Filter Housing Gasket Replacement

Model: BMW Serie 5 E61, E60 - Years 2003-2010
Part: Checks and maintenance

Open the hood and locate the oil filter position. Remove the cooling cover (simply clipped) located directly in front of the filter. Lift the front of the car using jack stands or a lift. Unscrew the screws that secure the plastic shield underneath the engine. Once done, keep the car raised only on the driver's side so it tilts to one side (passenger side). Disconnect the coolant line and let it drain into a container. Using a proper wrench, remove the oil cooling system in front of the filter. Remove the gasket from its housing with a screwdriver. Before inserting the new gasket, clean the part well. To reassemble, follow the same steps in reverse order. The car shown in the images is a BMW 5 Series.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Fixing Thermostat Housing Issues
Fixing Thermostat Housing Issues
BMW Serie 5 (1995-2003 / E39) Replacing the thermostat, a very important component in a vehicle, is usually within everyone's reach. However, sometimes issues can arise with its h…
Replacing the Power Steering Reservoir Cap Seal
Replacing the Power Steering Reservoir Cap Seal
BMW Serie 5 (1995-2003 / E39) If you notice oil leaks around the power steering reservoir cap, the underlying seal may be damaged: it is an o-ring made of rubber that, due to the …
Instructions for Replacing the Rear Window Seal
Instructions for Replacing the Rear Window Seal
BMW Serie 5 (1995-2003 / E39) To replace the rear window seal, first remove the corner segments at each corner. Then, carefully lift and pull out the actual seal with all necessar…

Other guides you may be interested in

How to Remove the Headrests from a Fiat Panda

Below are the instructions to remove the headrests, both front and rear, from the Fiat Panda. First, get inside the vehicle and press and hold the side button located at the base of the headrest. Then, while holding the button, pull the headrest upwards to remove it, as shown in the video. At this point, perform the same operation on the other headrests. Now, simply insert them back in while holding the button, and finally adjust the height of all the headrests!

Watch the video!


by ScegliAuto

More videos