Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Borile
    3. : Borile 500
In today's video tutorial, you will learn how to start the Borile 500 motorcycle by following the instructions provided below. First, turn the ignition key and open the fuel tap, then connect the positive terminal of the battery; next, pull the choke lever if starting from cold, and press the starter lever to start the engine of your motorcycle, as illustrated in the video. To turn off the motorcycle, simply turn the ignition key, following the video tutorial to the end!

Updated on 14 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Guide to Installing the Blockshaft on a Fiat 500
Guide to Installing the Blockshaft on a Fiat 500
Fiat 500 (2007-2021 / ) Today, in this guide, we will see the main procedure to install the blockshaft, or another model of engine ignition lock, on a Fiat 500. First, get i…
Removing the Starter Motor on a Fiat 500
Removing the Starter Motor on a Fiat 500
Fiat 500 (2007-2024 / 312) Need to replace the broken starter motor on a Fiat 500? Here’s how to remove it. Open and lift the front bonnet, disconnect the battery terminals. Lo…
Driving modes of the Fiat 500-E
Driving modes of the Fiat 500-E
Fiat 500 (2020-2026 / 500 E, 332) In this video we see the three driving modes selectable from the i-mode on the Fiat 500-e. The first is the "normal" mode, very similar to traditiona…

How to Reset the Engine Oil Light on a Yamaha XMax 250

This short video demonstrates the procedure to reset the engine oil light on a Yamaha XMax 250 scooter. The operation is very simple and quick; first, insert the motorcycle key into the designated slot and turn it to the first position to power on the instrument panel without starting the vehicle. At this point, you will see the light on the display; simply press the "oil change" button located at the centre of the motorcycle's speedometer and hold it until the light stops flashing. The operation will then be complete; to verify success, turn off and then turn on the instrument panel.

Watch the video!


by ScegliAuto

More videos