Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to Installing the Blockshaft on a Fiat 500

Model: Fiat 500 - Years 2007-2021

Today, in this guide, we will see the main procedure to install the blockshaft, or another model of engine ignition lock, on a Fiat 500. First, get inside the vehicle and start by removing the airbag, disconnecting the electrical connector at the back; then unscrew the central steering wheel bolt to remove it, as shown in the video. At this point, also disassemble the steering angle sensor by disconnecting the relevant connectors, and remove the steering column; then install the new ignition locking system, completing the necessary electrical wiring.

Updated on 14 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Brake Pads on the Fiat 500?
How to Replace the Brake Pads on the Fiat 500?
Fiat 500 (2007-2021 / ) To replace the brake pads on the Fiat 500, position the jack so that the corresponding wheel is off the ground. Next, loosen the bolts securing the w…
How to replace the rear light bulb on a Fiat 500?
How to replace the rear light bulb on a Fiat 500?
Fiat 500 (2007-2021 / ) To replace the rear light bulb on a Fiat 500, open the bonnet to access the screws that secure the light to its housing. Once these bolts are removed…
How to Replace the Ignition Coils on a Fiat 500 Abarth?
How to Replace the Ignition Coils on a Fiat 500 Abarth?
Fiat 500 (2007-2022 / 312) To replace the ignition coils on a Fiat 500 Abarth, open the bonnet to access the components inside. You will need to loosen the retaining rings that…

Other guides you may be interested in

    Frequently Asked Questions

    • 500 2007-2022 - Where is the USB port fuse located on a Fiat 500? Read answer
    • 500 2007-2024 - What happens when the "uconnect" on Fiat 500 expires? Read answer
    • 500 2007-2024 - Where is the jack on the Fiat 500? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos