Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : Remove the ignition mtorino on Fiat 500

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2023
Part: Starter motor
Operation: Remove the ignition mtorino on Fiat 500

Replacing the broken ignition motor on a Fiat 500? Let's see how it disassembles. We open and lift the front hood, disconnect the terminals of the power supply to the battery. We locate the starter motor inside the engine compartment. With a socket wrench we unscrew the locking pins of the starter motor and remove the clamps that bring electricity to it. We extract the broken motor from the engine compartment. We assemble the new ignition motor with the connection of the power supply cables and with the attached tightening screws. Let's start the engine of our Fiat 500 and see if everything works.


Posted on 8 December 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 500 2007-2022 - What problems does the Fiat 500 starter have? Read Answer
    • 500 2012-2023 - How to solve the problem of the start & stop not working on the Fiat 500L? Read Answer
    • 500 2007-2021 - How much does it cost to replace the ignition lock of the Fiat 500? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos