Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Wishbone Bush of the Citroen Xsara

Model: Citroen Xsara MK 1 - Years 1997-2006
Part: Bushings

The instructions in this guide will illustrate how to remove and replace the wishbone bush of the Citroen Xsara. First, lift the vehicle and start by removing the front wheel; then disconnect the link of the wishbone using two spanners, as shown in the video. At this point, disconnect and remove the wishbone, then proceed with the replacement of the bush using the appropriate tools; finally, reassemble the wishbone and the steering tie rods with the ball joints, following the video tutorial to the end!

Posted on 27 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the alternator of the Citroen Xsara 1.6
Replacement of the alternator of the Citroen Xsara 1.6
Citroen Xsara (1997-2006 / MK 1) These short and simple instructions will show us how to disassemble and replace the alternator of the Citroen Xsara. First of all, we open the engine…
How to Replace the Starter Motor on a Citroen Xsara?
How to Replace the Starter Motor on a Citroen Xsara?
Citroen Xsara (1997-2006 / MK 1) In this tutorial, you will see how to replace the starter motor on a Citroen Xsara, a simple operation if you have good manual skills. First, disconn…
How to remove the front seat of the Citroen Xsara
How to remove the front seat of the Citroen Xsara
Citroen Xsara (1997-2006 / MK 1) Today we will see the instructions that will allow us to disassemble and replace the front seat of the Citroen Xsara, in simple and quick steps. Firs…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos