|
Do it yourself
| |||
| ||||
How to Install the Spare Wheel on a Fiat Ducato/Peugeot Boxer and Citroen Jumper
Model: Citroen Jumper
MK 3
- Years:
2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024
Video tutorial
To install the spare wheel on a Fiat Ducato, Peugeot Boxer, or Citroen Jumper, proceed as follows: the spare wheel is usually located under the rear floor. To lower it, insert the winding lever into the designated hole (at the rear or side) and turn it counterclockwise until the steel cable and wheel lower. Release the safety hook, remove the wheel, and lift the vehicle with the jack at the indicated points (near the wheels, on the frame reinforcements). Unscrew the bolts of the punctured wheel (counterclockwise), mount the spare by aligning the holes, lightly screw the bolts by hand, then tighten them in a crisscross pattern with the spanner. Lower the vehicle, finish tightening the bolts, and store the punctured wheel under the floor, securing it to the cable and turning the winding lever clockwise to raise it. Check the pressure of the spare before setting off.
Posted on 10 September 2026 by ScegliAuto
Related tutorials
Citroen Jumper
(2014-2024 /
MK 3)
In today's video tutorial, you will see how to remove and replace the original car radio with an Android unit on a Citroen Jumper, as well as on a Pe…
Citroen Jumper
(2006-2014 /
MK 2)
Today's steps will show you how to remove and replace the front headlight of the Citroen Jumper, as well as the Fiat Ducato and Peugeot Boxer. First,…
Citroen Jumper
(2014-2024 /
MK 3)
Today, we will go through the instructions to remove and replace the front headlamp bulb on the Citroen Jumper, as well as the Peugeot Boxer and Fiat…
Other guides you may be interested in
|
How to Reset the Tyre Pressure Warning Light on a Kia Rio?
The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.117
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
