Do it yourself
| ||||
|
Datsun Redi Go - Video tutorial
Model: Datsun Redi Go
MK 1
- Years 2016-2023 Today we will see, in this video tutorial, how to remove and replace the Datsun Redi Go accelerator pedal. First of all, we get on board the car and start to unscrew the accelerator pedal bracket fixing screw; then we disconnect the metal cable and the accelerator position sensor electrical connector, as shown in the video. At this point we remove and replace the whole pedal with the new one, installing its original spare part; correctly fix the pedal to the bracket and connect the electric plug, following the video until the end!
Posted on 2 December 2022 by ScegliAuto
Other guides that may interest you |
Replace the steering angle sensor on the Volkswagen Golf 5When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.010
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |