Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Rear Spoiler on the Datsun Go

Model: Datsun Go MK 1 - Years 2013-2022
Part: Body

If you want to customize your vehicle by installing a rear spoiler, you can refer to the instructions provided below and use the images from the tutorial video. After purchasing an aftermarket accessory compatible with the vehicle, position the templates to drill the mounting holes for the spoiler on the sides of the hatch and at the center. Then, proceed to position the spoiler, removing the protective film from the adhesive first. Open the hatch and secure the screws from the inside that are included in the kit, and the job will be complete.

Updated on 7 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Fuel Filter on a Datsun Go?
How to Replace the Fuel Filter on a Datsun Go?
Datsun Go (2013-2022 / MK 1) To replace the fuel filter on a Datsun Go, access the underside of the vehicle near the fuel tank. Here, you will locate the fuel filter, which needs…
How to Install the Fender on a Datsun Go?
How to Install the Fender on a Datsun Go?
Datsun Go (2013-2022 / MK 1) If you frequently drive on dirt paths, it may be useful to install fenders on the wheels of the Datsun Go. You only need two tools: a drill and a scr…
How to Remove the Fuel Pump in the Datsun Go?
How to Remove the Fuel Pump in the Datsun Go?
Datsun Go (2013-2022 / MK 1) In this tutorial, see how to remove the fuel pump in the Datsun Go, a very simple operation. First, ensure the key is not in the ignition for safety.…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos