Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Flywheel and Fan from the Derbi Atlantis

Model: Derbi Atlantis
Part:

Video tutorial

Today, we will see the procedure for removing and replacing the flywheel and its fan on the Derbi Atlantis, following the instructions below. First, place the scooter on the centre stand and start by removing the flywheel cover by unscrewing the fixing screws; then proceed to remove the fan, accessing the front of the flywheel, as shown in the video.

At this point, unscrew the flywheel screws and use a puller if necessary; this will allow access to the stator for servicing or replacing components!


Updated on 22 October 2026 by ScegliAuto


Related tutorials

How to replace the exhaust on a Derbi Atlantis
How to replace the exhaust on a Derbi Atlantis
Atlantis Today, we will go through the instructions to remove and replace the exhaust on the Derbi Atlantis scooter in simple and quick steps. First, place th…
Removing the Clutch Cover on a Derbi Atlantis
Removing the Clutch Cover on a Derbi Atlantis
Atlantis Today, we will see, in this short and simple guide, how to remove and replace the clutch cover on the Derbi Atlantis scooter, following the instructi…
How to Remove the Front Suspension of the Derbi Atlantis
How to Remove the Front Suspension of the Derbi Atlantis
Atlantis To remove the suspension from the Derbi Atlantis, loosen the nuts that secure the front wheel spindle. By removing these nuts, you can slide out the …
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Reset the Engine Light on a Yamaha Ray RZ?

To reset the engine light on a Yamaha Ray RZ, connect a diagnostic tool to the vehicle's OBD port. The OBD port is located just above the battery housing, accessible by removing the panel in the centre of the footwell. Once this panel is removed, connect the scanner and select the car model and its corresponding version. After connecting the scanner and following the tutorial steps, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos