Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the clutch springs of the Derbi Variant?

Model: Derbi Variant 50
Part: Clutch

Video tutorial

In order to replace the clutch springs of the Derbi Variant, you have to completely remove this component from its housing: the clutch is located in the transmission housing, next to the rear wheel on the left side of the motorcycle. Once the old clutch has been removed, you will be able to locate the springs inside the clutch: by loosening the screws that hold them in place, you can remove them from their seat in order to insert the new ones.

After installation, you can reinsert the clutch and check that everything is functioning properly.


Posted on 14 June 2025 by ScegliAuto


Related tutorials

How do you replace the clutch on a Derbi Variant 50?
Variant 50 To replace the clutch of the Derbi Variant 50, you need to loosen the screws that secure the transmission cover located on the right side of the moto…
How do you disassemble the engine of the Derbi Variant?
How do you disassemble the engine of the Derbi Variant?
Variant 50 To perform the operation of the Derbi Variant engine, you can loosen the screws that fix the block to its housing in the central lower part of the fr…
How do you disassemble the engine of the Derbi Variant?
How do you disassemble the engine of the Derbi Variant?
Variant 50 The disassembly of the Derbi Variant engine can be done by loosening the screws that secure the cylinder to the top of the engine block, so that it c…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Reset the Engine Light on a Yamaha Ray RZ?

To reset the engine light on a Yamaha Ray RZ, connect a diagnostic tool to the vehicle's OBD port. The OBD port is located just above the battery housing, accessible by removing the panel in the centre of the footwell. Once this panel is removed, connect the scanner and select the car model and its corresponding version. After connecting the scanner and following the tutorial steps, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos